R motion - NSX race build

[drmikey]

A little more progress. Whilst there hasnt been any developments on the bodykit (bodyshops eh!) I have started reinstalling the loom and fitting the custom steering setup.

Since its more road/track orientated build now, I decided to reuse the existing loom with some stripping of unwanted wiring and a good tidy. This will just run the cars ancillaries. I will have a standlone loom and system for the engine.

Been a lot of trial and error to fit the EPAS system to the car using a manual NSX rack I had with the EPAS system. But in the end using a combination of the GM unit, NSX and EP3 parts it fits perfectly and the UJ movement is perfect. I have even managed to get the existing steering wheel surround to fit

The EPAS unit with modified UJ and column



Alignment of the column is perfect. I hope you like my (ahem) Type R pedals



Custom installed GM EPAS



Not a bad OEM look

[drmikey]

Not a great amount of progress, just some more shopping!

[reg]

It's great seeing it being re-built, I thought it had long since been destroyed......following with interest.

[drmikey]

Currently off at Fiberworx to have the body kit fitted and extensively modified!

[drmikey]

The push is on. Will be ready for the spring

Engine overhauled and ITBs on. Modified cooling system.

[NSXGB]

Are you installing a different body-kit now or sourcing OE panels?

[drmikey]

Are you installing a different body-kit now or sourcing OE panels?

OE Panels Simon. Comparing them to the kit I had, they are a work of art!

[NSXGB]

Nice one Mike, hope you didn't sell them all...

[drmikey]

Nice one Mike, hope you didn't sell them all...

Already sorted

[drmikey]

Some progress on my track NSX. Flocked dash in, temporary dash panel installed, AIM MXG up and running. Just need to get a couple of oil fittings and then off for mapping.