Activity Stream

Certainly an improvement :)

Well spotted Lars.... Here are some of them finished, a lot better than they were but not like new, just need to get the car re-sprayed now..........

A nice idea and realization - I'm currently fighting with reconnecting an OP amp where all connection points and PCB traces have been eaten away -...

No offence but could it be that the "after" picture is missing?

Seems I can only upload a limited amount of photos to each post, hence the reason for this second post to continue the story. I also bought...

I haven't posted for sometime on my ongoing maintenance of my NSX, mainly as I've not needed to but this year I needed to tackle the gearbox and...

Hi, welcome to the NSX world of fun! I'm also in Bucks and take my car to Honda Kidlington, part of the Johnsons group. They have been servicing my...

New EPT sealer to reduce the chance of the dust to get behind the clear lens. All illumination light bulbs replaced with the new ones. ...

Earlier last week, the owner collected his NSX and I’m now servicing another one from this week. So, wanted to finish this gauge cluster service...

A view from the cheap seats. The fuel resistor block and its insulation is pretty generic. A look on eBay will show similar units as fitted to...

Thank you.

Roof holder switch sub harness. It triggers the NSX-T roof warning if the roof R&L latch/lock were not fully engaged or if the roof was removed but...

Ah, the new one - I was thinking "who is till using the old one" :D

I'm writing down some more information that they've asked me for. The interior width measurement where the seat fits is 43 cm. The width...

https://www.amayama.com/en/part/honda/16717pr7j01 tho i did buy it with other parts to dilute the shipping!

Hi Jonathan, Pleased to read the BMW driver gave you space and didn’t rear end you! If the IGSW replacement isnt the cause of my issue, he fuel...

Thanks for the write-up - gotta use the time when the server is up :)

Could be helpful - underlying the main point "Resistance is futile" - sorry :-S - is this another part I have to add to my spares store?

finally, FINALLY, got around the doing my AC overhaul...... a long time in the making!!! details here!!!!...

And back to aircon direct for the regas…. IMG_20250314_091750 by JON SUTH, on Flickr Vacuum the system and do the leak test…. (cross fingers I...

So glad I got new hoses….. however, some time they had tweaked bolt lengths (probably as R134 runs at a lower pressure than R12) so the clamp heights...

The new and the old, both brackets in the same place, the compressor moved up, and the difference taken up in the offset of the pully, so that ends...

Step 3… the rear end! Car up on ramps, front end jacked up on axle stands, and the removal process begins, cross braces, tie strap bits and...