Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: Today's rolling road

  1. #1
    m666 edd Guest

    Default Today's rolling road

    I went to a rolling road day at Bridgwater today and got some strange results.

    Since I bought the car from Kev I had used a couple of tanks of normal 95 octane fuel then since I've used shell vpower.

    My thought behind it was as this car has a mugen chip, surely it's mapped to take advantage of higher octane fuel otherwise there'd be little point / benefit. My other car has different software and is recommended to use 99 octane fuel so this also made me think this. Since using the 99 octane fuel it certainly has felt faster.

    I know these results bare little relevance to other figures on this forum but thought they might be of interest:



    I can't really believe it has 100bhp transmission losses. They had trouble finding somewhere to strap the car down and I'm not sure what they strapped it to in the end. I certainly wasn't impressed by their knowledge either.

    The flywheel figures always seem pretty good from this particular rolling road (used it 2 or 3 times in the past). Standard cars were getting the figures they were supposed to and there were a fair few people getting less than they were expecting.

    I believe Kev got ~280bhp? last time he had it rolled at TDI and I think the changes since then are the exhaust manifolds and the fuel?

    Guess I need to go to TDI but its stupidly far away

  2. #2

    Default

    That doesn't look right to me either, but I'm sure Noel or Mark will read this soon and will be able to make sense of it.
    2005 NA2 NSX, Berlina Black with full red leather interior.
    2016 NC1 NSX, Casino White Pearl with red semi-aniline leather and alcantara.

  3. #3

    Default

    Your transmission loss is similar to what a Maha dyno showed for Procar’s NSX in Germany.



    Your NSX: 32.0% transmission loss on a Maha rolling road dyno
    Procar's NSX: 26.6% transmission loss on a Maha rolling road dyno
    For comparison:
    Austrian Type-R's NSX: 16.3% transmission loss on a Bosch rolling road dyno
    My NSX: 10.4% transmission loss on a Bosch rolling road dyno

    I cannot believe the transmission losses vary so much among NSXs. It simply cannot be that your transmission swallows three times as much power as mine. Unless your transmission is filled with sand and mine with Teflon, the loss measurements must be wrong.

    Personally, I don’t trust the power measurements at the wheel, either. A Clayton Hydrokinetic Chassis Roll Dynamometer measured 408 hp at the rear wheels of my NSX. Fantastic! A Bosch FLA-203 rolling road dyno only measured 270 rwhp, but that’s still good. The Dynolicious app on my iPhone spat out 238 rwhp. And my car was in the same state of tune for all three of those supposedly accurate “measurements”. So I don’t think you can compare results from different dynos.

    Almost no dynos are regularly calibrated, so God only knows how far out of calibration a specific dyno will be when your car is on it. It’s better to compare the results from one and the same dyno but even that can be problematic if the measurements were carried out at different points in time. LoveFab in the US developed a new exhaust system for the NSX in 2009 and measured the gain versus stock. First they measured the stock rwhp and came up with 229.0 rwhp. Then they built and installed their new exhaust system and went back to the same dyno: 274.5 rwhp, or a gain of 45.5 hp at the wheels. Just to be sure, they went back to the dyno and carried out both measurements on the same day. This time, they only came up with a gain of 22.3 hp at the wheels. The stock measurement was higher than before and the modified measurement was lower. LoveFab’s lesson learned was, “The best comparison results can only be gathered by testing components as close to back-to-back as possible.”

    Therefore, measuring on the same dyno on the same day is a great tool for comparing differences. If you go to a TDI dyno day, you can get a very good idea what kind of power your NSX puts out compared to other NSXs.

  4. #4
    Join Date
    Jun 2003
    Location
    Chexbres, Switzerland
    Posts
    525

    Default

    Dude, don't be questioning the figures. You got the bragging rights now, 312bhp. It's on paper, don't question it.

    The oil in the gearbox is not standard. Because of the requirements of the diff, the oil is thicker than normal Honda MTF.

    I have never tested it at TDI. It was tested at Power Engineering before. The exhaust headers are the only thing added to the car since I dynoed it, but I also added the cats as well.

  5. #5
    m666 edd Guest

    Default

    I might take it down to AP Motors in Plymouth at some point. They have a better setup, know what they're doing and explain things.

    The car certainly got a lot of attention considering I took it to a primarily Astra meet and was easily the loudest.

    A nice pic that was taken:



    Note theres no orange in the front indicators anymore. Still haven't removed the fogs though!

  6. #6
    Join Date
    Jun 2003
    Location
    Chexbres, Switzerland
    Posts
    525

    Default

    Easily the loudest? You need to drop the cats out one day and put the test pipes in!! As I have fitted stainless bolts to the cats, you can swap them in 10 minutes.

    You don't know loud until you do that.

  7. #7
    m666 edd Guest

    Default

    I thought you might say something like that.

    I'm really tempted to stick them in and see what it's like with the inserts in. If it's ok then I can have fun more easily

  8. #8

    Default

    On a seperate note, the car looks fab!
    1999 3.2 Manual 6 Spd Coupe
    Honda's Finest Hour

  9. #9
    Join Date
    Apr 2004
    Location
    West Sussex
    Posts
    4,541

    Default

    Car looks really good and the white wheels suit it well. I nearly bought a black NSX, very sleek colour.

    Would have gone for the smoke coloured indicators instead of white, but definitely an improvement on the amber ones.

  10. #10

    Default

    Quote Originally Posted by forumadmin View Post
    Easily the loudest? You need to drop the cats out one day and put the test pipes in!! As I have fitted stainless bolts to the cats, you can swap them in 10 minutes.

    You don't know loud until you do that.
    Quote Originally Posted by forumadmin View Post
    Dude, don't be questioning the figures. You got the bragging rights now, 312bhp. It's on paper, don't question it.

    The oil in the gearbox is not standard. Because of the requirements of the diff, the oil is thicker than normal Honda MTF.

    I have never tested it at TDI. It was tested at Power Engineering before. The exhaust headers are the only thing added to the car since I dynoed it, but I also added the cats as well.
    Quote Originally Posted by m666 edd View Post
    I might take it down to AP Motors in Plymouth at some point. They have a better setup, know what they're doing and explain things.

    The car certainly got a lot of attention considering I took it to a primarily Astra meet and was easily the loudest.
    There was a clip of us at that dyno day, do you still have it? The pictures I had were on my old lap top that got nicked
    2005 NA2 NSX, Berlina Black with full red leather interior.
    2016 NC1 NSX, Casino White Pearl with red semi-aniline leather and alcantara.

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •