Started to overhaul the drive shaft. Cleaned the joint housing to this level for inspection. The roller, tripod/spider, housing, shaft are specially heat treated and hardened several times so you must place each parts in their original direction/position on reassembly. The original grease was already ...
In January, I received an email from Honda regarding the display of NSX Concept model at the Headquarters showroom in Aoyama, Tokyo, Japan on the first weekend of February. Although I couldn’t make it, there were lots of video clips posted on YouTube. One example; Not much point in discussing about the detail of the design ...
As some of the parts arrived today, decided to finish off the Eng/Transmission mount area ahead of the drive shaft overhaul. Heat shield for front header installed with new bolts. Although it’s been treated, it will corrode again within a short period. ...
Drained the MTF. As always, any trans fluid smells bad..... Finally, the MTF strainer cover came off. It was heavily corroded and didn’t want to come off. There were tiny particles and metal ...
After spending some time on how to fire up the engine under current condition, re-connected the O2 sensor and started the preparation for the fire up. While trying to re-install the battery, found lots of packing foam under it. This is the cat sand like material covering the entire battery when you buy ...
Recent Comments
