Compression check after the Eng Refresh service. Full data has been forwarded to the owner. Yes, Im biased because I have carried out the engine refresh on this engine, but still, really pleased with the result. So much better than before and all six cyl really close each other. [psi] ...
Cam pulley installed and torqued to the spec. WP installed. Unlike the old one, no need to use the liquid gasket here. ...
As mentioned in the previous post; Eng Refresh Stage 1 06, the locking pin wont fit at the front bank exhaust side on early model engine even at the correct valve timing so you should not rely on the holes at the ...
Updated 06-11-2012 at 01:12 PM by Kaz-kzukNA1
Spent long time cleaning the engine bay while the engine was out. It became clear that most of the corrosion protection oil was already burnt into the paint surface and would not come off without using strong chemical or polish. Decided to clean as much as possible only with the safe method. It was the same on the engine, Gbox and the surrounding area. The brown/yellow burnt oil wont come off even using the ...
Updated 05-11-2012 at 01:46 PM by Kaz-kzukNA1
Had to focus on another project today so just a quick update including the process before I was cut short by the dishwasher problem. Double checked that the crank was still at the #1 TDC. ...
Updated 24-09-2012 at 10:03 AM by Kaz-kzukNA1 (Revised blog category.)