Eng oil was really black and there were lots of oil mist at the rubber joint between the TH body and the air box so the PCV valve may need replacing. It was very dirty any way. Despite the above fact and although it will still require extra time cleaning the internal parts, the rear bank was not too bad. ...
Updated 18-04-2014 at 01:23 PM by Kaz-kzukNA1
Started the disassembly process. IAT sensor covered in black oil and debris. Will be cleaned and replace the o-ring. With the blowby gas routing on the black valve covers, normally, the ...
I think this WP is at the end of its life. Valve covers. Quite surprised with more gunk at the rear bank than the front one. With this blowby ...
Small contamination trapped at the VTEC spool valve filter. Its the later spec one so the solenoid has smaller diameter (about 25mm) compared ...