Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

By the end of yesterday, I was hoping to finish replacing all coolant hoses but with so many corroded pipes, flange at the thermostat and dirty TH body and intake manifold, had to leave the last two hoses at the oil cooler for tomorrow and then fire up the engine.



...

Tags: coolant hose, coolant pipe, header tank, thermostat

Categories

Cooling

Nothing new or special here.
Just remove the old coolant hoses and replace them with the new ones.




Even for this low mileage, fairly late model NSX, the corrosion at the cooing sys pipes already started so
it was a very good decision to carry out the cooling sys refresh this time.
Saves the time and cost for the owner. ...

Tags: coolant hose, cooling sys, thermostat

Categories

Cooling

TH body and butterfly are now very clean.
I thought about removing the idle air adj screw and replace it with
a new one but after spraying it with the carb cleaner, it looked so much
better. For now, I’m going ...

Tags: coolant hose, egr valve, th body, th butterfly, thermostat

Categories

Eng Refresh Stage 1 + LMA

V-bank coolant pipe back in place.
Used to look like this.








As ...

Tags: coolant pipe, thermostat, timing belt, water passage

Categories

Eng Refresh Stage 1 + LMA

New thermostat installed.






Looks so much better after washing the TH body.
...

Tags: cl hose, cl release fork, cl slave cyl, th body, thermostat

Categories

TB/WP/Valve Service , Clutch Master/Slave Cyl