View RSS Feed

TB/WP/Valve Service

  1. Eng Refresh, Health Check, etc 38

    by , 20-02-2015 at 10:17 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    Already carried out short distance test driving session in order to get idea on when the owner can collect his NSX.


    Back on the lift, happy with the result so time for the 30min cruising mode session. On the way back, activated VTEC and entered the high rpm range once.

    Back to cruising mode and cool down session.

    Double checked that there is no air at the heater core and radiator bleeder plugs.
    ...

    Updated 21-02-2015 at 08:20 PM by Kaz-kzukNA1

    Categories
    TB/WP/Valve Service
  2. Eng Refresh, Health Check, etc 37

    by , 20-02-2015 at 10:16 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    Didn't like the level of corrosion at the brake banjo bolt so replaced both RR & RL ones.
    Bleeder screws were fine at all four corners so just re-used them.

    As we are not replacing the Brake master cyl, ...

    Updated 21-02-2015 at 08:23 PM by Kaz-kzukNA1

    Categories
    TB/WP/Valve Service
  3. Eng Refresh, Health Check, etc 36

    by , 19-02-2015 at 01:44 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)













    Vacuum leak check of the cooling system.




    While waiting for the leak check, started bleeding the CL Hyd sys.
    This NSX is LEV model ...
  4. Eng Refresh, Health Check, etc 35

    by , 19-02-2015 at 01:36 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    Already fired up the engine so doing another catch up.....





    Replaced three coolant hoses under the centre floor.

    As seen on several NSX, already two of the hoses were very soft and was not surprised if they burst in the near future. Good call to replace them now.
    Also, three of the pipe end were heavily
    ...
  5. Eng Refresh, Health Check, etc 34

    by , 16-02-2015 at 12:09 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    Applied silicone grease around all of the rubber hunger of the aftermarket exhaust back box.

    All of them were making squeaking noise and in order to align the tail end pipe against the rear bumper, always torque the bolts and nuts from ...
Page 1 of 56 1231151 ... LastLast