View RSS Feed

Uncategorized

Entries with no category

  1. Drive shaft 03

    by , 28-02-2011 at 11:47 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    The owner cleaned the MTF strainer recently.

    Click image for larger version. 

Name:	TransCase.JPG 
Views:	18757 
Size:	193.1 KB 
ID:	8682

    Whenever I drain the MTF, I always check the state of the strainer to understand the condition of the transmission.


    The big particles will be trapped by the magnet plate at the bottom of the trans case but the metal powder and small particles are held inside this strainer before going through the oil pump.


    For this NSX, as the owner has already ...
    Tags: drive shaft, mtf Add / Edit Tags
    Categories
    Uncategorized
  2. Drive shaft 02

    by , 28-02-2011 at 11:45 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    Now the Left side.



    Click image for larger version. 

Name:	LeftDriveShaftLeaked01.JPG 
Views:	18709 
Size:	183.0 KB 
ID:	8677


    The outboard joint was slashing the grease everywhere over the years and it managed to create wall of grease in many areas….



    I think I’ll be spending extra hours cleaning them…



    Click image for larger version. 

Name:	LeftDriveShaftLeaked02.JPG 
Views:	18464 
Size:	162.9 KB 
ID:	8676


    Click image for larger version. 

Name:	LeftTriggerTeeth02.JPG 
Views:	18505 
Size:	162.9 KB 
ID:	8678 Click image for larger version. 

Name:	LeftTriggerTeeth01.JPG 
Views:	18366 
Size:	150.5 KB 
ID:	8679


    The trigger teeth had lots of debris but it ...

    Updated 01-03-2011 at 02:50 PM by Kaz-kzukNA1

    Categories
    Uncategorized
  3. Drive shaft 01

    by , 28-02-2011 at 11:40 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    Some of the readers here may have experienced the same thing…


    For some reason, once I started working on a specific part on one NSX, then the trend seems to follow for the following cars waiting to be serviced.


    For a while, I was overhauling lots of brake callipers on many NSX for a few months.


    Then, the trend changed to the timing belt service and now back to the drive shaft.



    When the owner brought ...
    Tags: drive shaft Add / Edit Tags
    Categories
    Uncategorized
  4. Crank Pulley 01

    by , 28-02-2011 at 11:35 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)
    Although this NSX had several timing belt service in the past, as seen on almost all of the UK NSX, the crank pulley was never replaced after leaving the factory in Japan.

    Click image for larger version. 

Name:	CrankPulley01.JPG 
Views:	38111 
Size:	179.5 KB 
ID:	8670


    So, it’s time to replace it.


    This NSX has very low mileage for its age and the owner looked after it very well that there were not much rust around the lower part of the chassis.


    However, after removing the crank pulley, ...
    Tags: crank pulley Add / Edit Tags
    Categories
    Uncategorized
  5. Service based on Health Check

    by , 28-02-2011 at 11:31 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)


    It was a very busy weekend.

    First thing in the morning on Saturday, I went to Oxford to be the marriage witness for one of my best friend.


    Very nice couple and wish them all the best for their future family as well.


    Then, Sunday morning, one owner visited my place to collect his NSX.


    I hope the owner can address some of the points that we discussed for the preparation of future services. ...
    Tags: health check Add / Edit Tags
    Categories
    Uncategorized
Page 1 of 11 123 ... LastLast