Activity Stream

It's the LH hinge that has fatigued & if I move the lid again, I think it will finally snap. The RH hinge has signs of fatiguing, as there is a crack...

Is it metal fatigue in the hinge, or the boot lid itself? - i can’t tell from the pictures. The hinges aren’t too expensive, but the boot lid is...

Not so common as the main relay failure but unfortunately, already enough issue reported. And indeed, some experienced with snapped hinge. On...

That's another option, but a re-gas would be most simple, I guess :)

Any help as a DIY with generic struts? http://www.nsxcb.co.uk/showthread.php?16035-Glass-hatch-struts-on-a-budget&p=131537#post131537

Perhaps that explains why my 2000 6 speed is very 'cranky' when cold. You need to be relatively slow and deliberate on the 1 - 2 and to a lesser...

I had a similar issue, but rather than going for re-gassing, I purchased aftermarket struts from Science of Speed. Jim

If there's no other option, I would rather prefer to order new ones from Honda.

Is Christian at ATR worth a try for second or new?

After writing to them, SGS would service the struts but can't send them back - that seems to be a dead end. Contacts with several gas strut...

I have my downloaded tickets, hopefully the car pass is at home waiting for me

Car Club pass for the car in today’s post. We are located on the hard standing behind the national paddock area. Entry tickets for driver &...

Hi Jonathan, great update and a lot of work done. My bumper bars were in a similar corroded state when I got the bumpers off, and now I know why you...

Hi All, Been away a few days so sorry for late follow up, I thought changing the header before I went away might help … so apologies for those who...

here's the before and after.... bearing in mind i'd darkened the green down significantly!!! and now it's just before Beaulieu supercars, and my...

as i have been somewhat remiss updating this thread, here's an update as to what i've been doing lately...... the shiny new JDM rear lights i...

Not scientific measurement but I normally pour about 2.7 - 2.8L of MTF into the Gbox and wait for the excess to drain out. So, if you were only able...

Probably not too much of problem if transported within Europe but just a reminder. Please check the restriction on the delivery method. The gas...

Thanks for the tip, that's a good starting point or potential option :)

Hi Heiniken, if you don't mind sending them to the UK, SGS Engineering is a company that many (Inc. me) have used with success.

Kaz, I'm not sure if it had an aftermarket diff, I can only put 2 and a quarter liters of oil in. What is the correct amount from your experience?...

A suggestion as to a possible cause. At some prior point in time, was a friction modified transmission oil such as Red Line MTL or GM Synchromesh...

Thank you for the update, Phil. Interesting. OEM DF (differential) or aftermarket one??? I know fair amount of owners in US used 'cocktail'...

So just a little update on my side. I replaced the diff oil from Honda MTF-3 to Royal Purple and the noise had disappeared.

1. Rich (L696) 2. Paul (Senninha) 3. Duncan (Duncan) 4th=yes, 18th=no 4. NSX 2000 4th=No, 18th=yes 5. Silver Surfer 4th= Y 18th= Y 6. NSXGB 4th....

1. Rich (L696) 2. Paul (Senninha) 3. Duncan (Duncan) 4th=yes, 18th=no 4. NSX 2000 4th=No, 18th=yes 5. Silver Surfer 4th= Y 18th= Y 6. NSXGB 4th....