Activity Stream

Filter

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums Articles Articles Blog Blogs

Filter by: Last 7 Days

Clear All

Older Activity
Yesterday, 10:45 PM

Senninha replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

NZNick ,,, This is how I have mine set up too …

see more

20 replies | 4459 view(s)
Yesterday, 07:30 PM

thelimpingwhippet replied to a thread scrap cats in NSX Technical (1st Gen)

Kaz, sorry if this is a repeat reply. The new cats came from the States and seem to match perfectly although I have yet to fit them. All the best...

see more

2 replies | 80 view(s)
Yesterday, 05:37 PM

priesh started a thread Latest oil filter part number? in NSX Technical (1st Gen)

Hi all - what is the latest correct part number for the oil filter? I think it is 15400-PL2-306, but just wanted to confirm. Cheers!

see more

0 replies | 28 view(s)
Yesterday, 10:46 AM

priesh replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

Hopefully you'll figure out what happened. You can get a battery health tester to see what condition the battery is in. Like you say it probably was...

see more

20 replies | 4459 view(s)
11-12-2024, 10:59 AM

goldtop replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

Not switched off, as far as I know. Unless there was a power cut at the workshop? (Bizarre that the CTEK wouldn't have a simple diode fitted to...

see more

20 replies | 4459 view(s)
10-12-2024, 07:53 PM

britlude replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

did the ctek get switched off at the power source? i found that if its not powered up, but still connected to the battery it WILL discharge the...

see more

20 replies | 4459 view(s)
10-12-2024, 07:05 PM

goldtop replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

Yes, this one has worked fine for several months. I checked it every morning. Am hoping it was just a bad battery.

see more

20 replies | 4459 view(s)
10-12-2024, 05:48 PM

sorepaws replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

I have a CTEK MX5 - it has been used without any problems since 2018.

see more

20 replies | 4459 view(s)
10-12-2024, 04:07 PM

Kaz-kzukNA1 replied to a thread scrap cats in NSX Technical (1st Gen)

Can't help with the value but hope you ordered the correct spec. OBD-II was introduced at much earlier stage with Acura than Europe. Ofcourse, if...

see more

2 replies | 80 view(s)
10-12-2024, 12:55 PM

thelimpingwhippet started a thread scrap cats in NSX Technical (1st Gen)

Having finally grown up at last I no longer relish the prospect of hooning around the back lanes of Shropshire until my catalytic converters are...

see more

2 replies | 80 view(s)
10-12-2024, 11:23 AM

goldtop replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

Without wishing to cause any unnecessary worries, the use of the CTEK MX5 seems to have killed my NSX's battery. It was working fine for several...

see more

20 replies | 4459 view(s)
10-12-2024, 09:45 AM

priesh replied to a thread Using Jump Start terminals for trickle charger? in NSX Technical (1st Gen)

Fitted the ctek this morning. Changed the 3 pin plug into a waterproof connector that then connects to an outdoor rated lead into my garage (NSX...

see more

20 replies | 4459 view(s)

No More Results

All times are GMT. The time now is 01:30 PM.

Powered by vBulletin® Version 4.2.4
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.