Hi Kaz

I've done the following today.

Inserted diagnostic loop


Car still in my garage, not been started since I previously since put away. See video here: https://www.dropbox.com/s/ii1gm0f6hx...%2012.mov?dl=0

Next I removed diagnostic loop and started car (without the issue as if had the ignition on and off a few times for the diagnostic video), drove it for 30 mins


Stopped. Inserted loop and did this video: https://www.dropbox.com/s/zchwvyk0ex...%2003.mov?dl=0


Then I removed the diagnostic loop


Tried to start car (from warm having been stopped about 5 mins), it failed with same issue. See video here: https://www.dropbox.com/s/ar93k7gw4p...%2048.mov?dl=0


Inserted the diagnostics loop. See final video here: https://www.dropbox.com/s/68viuzeyqw...%2034.mov?dl=0

Looking at the diagnostic pdf I think this is showing just the one error code of 4, is that correct ?

Thanks

Phil

Quote Originally Posted by Kaz-kzukNA1 View Post
Yes.
Can be used for both OBD1 and OBD2 spec.
Yours is OBD1 and DBW spec.
If not sure about the actual code, please take a video from IGSW in P0 Off position and try to include all readings including the volt gauge.

Even without triggering the warning light, it's worth reading the error code at least once a year.

Some of the error codes require two consecutive drive cycles or two detection within the same drive cycle before triggering the warning light.
Therefore, even without any warning lights, still, you may have error code stored on certain controllers.


Kaz