Too tight... Drive shaft 02
by
, 16-02-2011 at 10:24 PM (2193 Views)
After spending hours, finally, managed to move R & L drive shaft spline from the hub.
I had to apply so much pressure using the hydraulic puller that I thought I would break the tool.
I used this puller so many times but never had to apply this amount of force in the past.
As I need to have maximum space especially on the left drive shaft to pop out the inboard joint, I’m not going to move this any further.
Due to the extra hours being spent on this, I’m about 1 day behind the schedule.
Need to do some catch up tomorrow…
Kaz