Eng Refresh + LMA, etc 35
by
, 06-05-2017 at 11:00 AM (3042 Views)
Quick detailing in preparation for placing the eng back in to the bay.
Before/after
For now, set the idle air adj screw here and will adjust the base idle later.
When it arrived at my place, someone adjusted it in the past but way too open......
Just I though the eng related task was done, I completely forgotten about drilling out the 3 x CAT bolt that I had to cut when taking the eng out of the bay.
D'oh!
Should have done it before detailing…..
Back to work.
Hope I can start painting the drive shaft joint over this weekend but wind is not on my side….
My boss is flying back from Japan next week so that's going to be interesting as it will cause another delay but hope I can return this NSX very soon…..
Kaz