Brake OH 06
by
, 26-05-2011 at 11:37 PM (2030 Views)
Has been very busy this week with the other project so couldn’t spend much time on this NSX.
While working on the brake area, noticed that lots and lots of clips holding the plastic wheel arch inner trim were missing.
In fact, at the Rear left, almost all of them were missing.
Luckily, I had aftermarket spare ones so installed them on many places while the wheels were off the car.
The new brake master cyl.
Didn’t know the recent one has blue-ish colour on the reservoir tank.
Very unlikely that you need to adjust the pushrod clearance but as I don’t know what was done on this NSX in the past, always important to double check the clearance using the SST under specified vacuum pressure.