Old radiator out and needs good cleaning of the area. Gave good cleaning on the rad fan shroud. It’s missing the wire holder but I think I have enough in stock. ...
Thought not much to report while removing the parts and cleaning inside the engine but several inof for the owner. As reported earlier, the coolant was leaking from the WP. The bolt torque was lower at the leaked area. Because it was left for a long time, the corrosion managed to chew into the mating surface. ...
Just keep buidling the engine in preparation for the installation. New two coolant hoses at the oil cooler. The rust around the hose was fairly thick but the other side was fine so for now, ...
As expected, the IAT sensor was covered in oil and full of debris. Cleaned it and replaced the o-ring. Should read the correct temperature now. ...
I know from the previous email exchange that the owner ...
Updated 07-08-2014 at 01:56 PM by Kaz-kzukNA1 (Additional info regarding the fuel cap)