Doing bit of catch up as the engine has already been fired up...... Fresh Mobil 1 into the new oil filter. Extracted about 400cc old oil from the oil level gauge ...
Updated 18-05-2013 at 10:32 AM by Kaz-kzukNA1
Intake Air Temperature (IAT) sensor. Covered in oil with lots of black debris. Cleaned it and although I couldn’t take the photo under good lighting, it should look ...
Updated 16-05-2013 at 10:42 AM by Kaz-kzukNA1
This aftermarket header is about 5mm too short for both the front and rear bank. For OEM and other manifold/header, I have to tilt the CAT during the engine installation because the stud bolts will hit the mating flange. With this header, I didn’t have to do anything because ...
Updated 24-04-2013 at 07:54 AM by Kaz-kzukNA1