This is just an information purpose post on how to press out the seized drive shaft spindle/spline. I normally use hydraulic hub puller but if it doesn't work, followings are the recommended method. I tried to find the photo from my archive but couldn't find good ones so followings were gathered from Japanese website a while ago. I tried to remember from where I got these as I should put referrence to them for copyright reason but unfortunately, I couldn't extract ...
Updated 20-10-2014 at 08:10 AM by Kaz-kzukNA1 (extra info regarding hub carrier)
Over the last several days, I was tackling with the drive shafts on both R & L sides. As reported earlier, they were seized in the hub. First attempt using the hydraulic hub puller didn't work so I then drove the car for a while to put some heat and vibration ...
Blog Categories
Archive
Recent Comments
