Couldn’t take lots of photos while my hands were covered in oil dealing with lots of rocker arms, etc so just the end result. All four cam shafts removed, holder plate and cam holders are now soaked in the cleaning solution. Will inspect the cam shaft in detail later. Considering ...
Small contamination trapped at the VTEC spool valve filter. It’s the later spec one so the solenoid has smaller diameter (about 25mm) compared ...
Just keep removing the parts in preparation for taking the engine out. Once the engine is out, it’s not easy to apply huge torque at the crank pulley bolt so loosen it at this stage. ...
Updated 30-10-2012 at 11:16 AM by Kaz-kzukNA1
New design LMA installed in the pocket. New O-ring under the #1 cam holder. ...
Updated 24-09-2012 at 10:02 AM by Kaz-kzukNA1 (Revised blog category.)
Quite busy at the moment so just a quick updates. Finally, happy with the state of the front cyl head so started the LMA installation. The old tired LMA (left) and the new latest design one (right) with much longer durability. ...