Following on from the shocking first inspection of this board, http://www.nsxcb.co.uk/entry.php?108...d-service-A-01 decided to remove all the parts affected including the ones that were installed by the previous service. Very good idea because I found one of the zener diode was of wrong spec. ...
Managed to find the time to test the CCU board using my NSX. I don’t know how many times I removed my centre console for this purpose. When I started this service, I thought about getting complete 2nd hand heater unit and blower motor fan for the testing purpose but at that time, I didn’t know the level of demand and also couldn’t justify the total cost when I can remove the centre console so quickly. When I replace ...
Updated 18-10-2013 at 11:55 AM by Kaz-kzukNA1
Had to use so many hard wires and soldering bridges in order to re-create the missing tracks and pads. ...
Updated 16-10-2013 at 10:52 AM by Kaz-kzukNA1
As reported earlier, the A/C condenser fans and compressor switched themselves On despite the CCU being switched off. It is still possible that the Cooling fan control unit is faulty but decided to open ...
Updated 10-10-2013 at 11:34 AM by Kaz-kzukNA1
Doing bit of catch up updating the blog..... As the condition of CCU board ‘A-**’ looked so bad, decided to finish this ‘B-**’ one first. ...
Blog Categories
Archive
Recent Comments
