View RSS Feed

Recent Blogs Posts

  1. Cooling Sys, etc 22

    by , 20-04-2021 at 09:21 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)













    ...

    Updated 21-05-2021 at 03:22 PM by Kaz-kzukNA1

    Categories
    Electronics
  2. ABS Upgrade, Door Window Refresh, etc 12

    by , 19-06-2015 at 01:31 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)







    Have been tackling the door window alignment for many days recently with one nearly dead finger as a result.






    It looks like someone already mistreated some of the parts that I planned reusing and at the end, I had to make custom adjustments that were not on the workshop manual.
    ...
  3. ABS Upgrade, Door Window Refresh, etc 11

    by , 08-06-2015 at 03:47 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)








    Hm…. It’s dirty but you don’t want to apply any force in this area especially around the linkage and the plastic fasteners.
    Removing the rod from the linkage is easy if you know the trick but it’s time consuming
    ...
  4. ABS Upgrade, Door Window Refresh, etc 10

    by , 08-06-2015 at 03:41 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)











    European spec high pressure washer motor, grommet, seal sponge. The old motor was still active but lost pressure so already partially dead.

    Washer tube held with new bracket.
    ...
  5. ABS Upgrade, Door Window Refresh, etc 08

    by , 08-06-2015 at 03:11 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)










    I’m not going to bother repairing this protective sheet again….

    Will clean the old OEM white sticky sealant and replace the sheet.

    However, later, I found that addition to the black butyl sealant, someone used double sided tape under there.

    It was a nightmare removing them
    ...
Page 1 of 2 12 LastLast