View RSS Feed

Recent Blogs Posts

  1. Brake OH, Cooling Sys, etc 22

    by , 02-02-2018 at 10:40 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)












    ...

    Updated 06-02-2018 at 01:21 PM by Kaz-kzukNA1

    Categories
    Fuel and Emissions , Body
  2. Eng Refresh + LMA, Brake OH, etc 46

    by , 27-02-2017 at 12:14 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)











    As mentioned in my last post, considering the weather forecast, decided to go out for the test driving session
    even before completing the ABS and EPS controller services.

    ECU was already reset after adjusting the base idle air and after the compression check.

    Not sure how the temperature changes over the next few weeks,
    so decided to set the tyre pressure at the
    ...
  3. ABS Upgrade, Door Window Refresh, etc 10

    by , 08-06-2015 at 03:41 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)











    European spec high pressure washer motor, grommet, seal sponge. The old motor was still active but lost pressure so already partially dead.

    Washer tube held with new bracket.
    ...
  4. Koyo Rad, Cooling Sys, Washer motor 01

    by , 15-07-2014 at 02:23 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    Started to work on another NSX this week.
    The service menu is to replace the leaky radiator with all aluminium Koyo Rad, replace coolant hoses, etc.
    While the radiator is out of the way, I'll be looking at the dead washer motor as well.
    Also, will provide the owner with the parts required for overhauling the early spec brake caliper.


    Normally, I carry out the test driving session before start of the service to check the base line but I already knew
    ...
  5. Final Touch 05

    by , 23-05-2014 at 01:22 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    About to return this NSX to the owner so this is the final catch up updating the blog, for now.....




    I have now covered 65miles of test driving session including several VTEC moments
    and just one check of over 7,000rpm slope test.
    No issues and no warning lights, cool down mode and back on the lift.
    Visually
    ...
Page 1 of 2 12 LastLast