View RSS Feed

Recent Blogs Posts

  1. Brake OH, Cooling Sys, etc 12

    by , 14-01-2018 at 01:16 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)
  2. Annual Service, Health Check, Brake OH 05

    by , 08-08-2014 at 12:42 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)
    Started opening the calipers and had to inform the owner that I will need extra days.


    Even for the late production model close to 2005, if the caliper service was neglected, there is very little chance of surviving without the rust getting inside the caliper.
    This is especially true for UK based NSX even for the ones kept inside the nice beautiful garage.
    For some reason, caliper overhaul is not included in the standard Honda service schedule on all Honda models
    ...
  3. Koyo Rad, Cooling Sys, Washer motor 03

    by , 16-07-2014 at 10:19 AM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)

    New coolant hoses and cramps installed at the centre floor section and at the front compartment under the bonnet.




    ...
  4. Brake OH 01

    by , 12-07-2014 at 12:08 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)
    I thought it's going to be an easy life this week since I won't be working on another NSX until next week.
    Then, something came to my mind and suddenly I found myself placing the order for the front brake disc/pad and started disassembling the calipers....
    My boss was not impressed at all as it's her birthday very soon and we were supposed to be doing some shopping.....


    Moving on.....


    Ideally, I wanted to send the caliper and bracket to Bigg ...
  5. Brake OH 03

    by , 28-07-2012 at 10:37 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)



    After spending hours, finally I was happy to start re-building the rear caliper.






    Before and after shots of the pin bearing area at the cam lever.
    Also, the cyl wall is very clean now.

    ...
Page 1 of 2 12 LastLast