View RSS Feed

Recent Blogs Posts

  1. Eng Refresh + LMA, Health Check, etc 22

    by , 03-09-2017 at 06:41 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)










    Before removing the TB, measured the existing valve clearance.

    Out of 24 adjustments, only 7 of them were within the spec. Rest of them were all too wide.

    Apart from one of the inlet valve, remaining three adjustments were just a bit too wide at #3cyl so all valve stems were fine.













    ...
  2. Eng Refresh + LMA, Brake OH, etc 22

  3. Eng Refresh 10

    by , 18-04-2014 at 01:20 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    As I already knew about the head gasket issue, didn’t want to
    warm the engine up in preparation for the compression check and obviously,
    no test driving session.




    Instead, decided to carry out cold leakdown test.

    The engine is cold and it was parked nearly two weeks now so
    the data
    ...

    Updated 18-04-2014 at 01:24 PM by Kaz-kzukNA1

    Categories
    Eng Refresh Stage 1 + LMA
  4. Eng Refresh 12

    by , 23-10-2013 at 11:58 AM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    Finally, all of the cam holders were cleaned to this level with
    remaining of old liquid gasket removed thoroughly.




    I should have taken the back side of the holder pipe/plate because
    that
    ...
  5. Eng Refresh 14

    by , 06-09-2013 at 10:27 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)



    Time to install the camshafts.





    New O-ring under #1 cam holder.






    ...
Page 1 of 2 12 LastLast