Recent Blogs Posts

[Edit:] Message to the owner
Forgot to mention this in the previous post.

Despite having the later spec LMA, to my finger, the one at
the Inlet side of the #4 cyl felt tiny bit weaker than others.
It is possible that it's just my imagination as I didn't measure
the spring rate and just felt with my finger.
Nothing to concern and won't cause noise issue probably even
after the next TB service.

It's the same on any ...

Updated 06-03-2014 at 03:46 PM by Kaz-kzukNA1

Tags: a/c belt, acg belt, eng detailing, eng dressing, oil press sender, oil pressure sender unit, valve cover, valve cover gasket, vtec spool valve

Categories

TB/WP/Valve Service

3rd round of valve clearance adjustment done for both
the Front and Rear banks.


After hours of careful adjustment, finally, I’m happy with the result.



...

Tags: crank pulley, oil cooler, tb adjuster bolt seal, valve clearance

Categories

TB/WP/Valve Service