Hm…. It’s dirty but you don’t want to apply any force in this area especially around the linkage and the plastic fasteners. Removing the rod from the linkage is easy if you know the trick but it’s time consuming ...
European spec high pressure washer motor, grommet, seal sponge. The old motor was still active but lost pressure so already partially dead. Washer tube held with new bracket. ...
...
I’m not going to bother repairing this protective sheet again…. Will clean the old OEM white sticky sealant and replace the sheet. However, later, I found that addition to the black butyl sealant, someone used double sided tape under there. It was a nightmare removing them ...
Started working on the Door window refresh from few days ago. Normally, you would take some video to show before/after of the refresh but there was not much point as the owner couldn’t even lower the window if the door was closed at the left side. The right side was somewhat better but I found out that someone already worked in the door section in the past and touched the window alignment so not relevant. ...