In order to be as close as possible with the OEM rideheight, I'll set the C-ring at the upper perch. Using the lower perch will lower the rideheight about 25mm depending on the lever ratio. Because of using the new rubber parts, we can't carry out the alignment service immediately until the damper/spring ...
Started the installation of Bilstein damper but I accidentally deleted all of the photos except one that I took on Monday. Fortunately, it's just the repeat of same procedures so not perfect but took similar photos again. Originally, we were talking about installing the BC Coilover kit with Swift spring upgrade. However, after discussing the rideheight requirement with the owner, it became clear that it has to be very close to the OEM ...