Just keep preparing for the engine removal…. Loosen the crank pulley bolt before taking the engine out. No drama as I already replaced this crank pulley for the owner in the past and followed the specific procedure before re-installing the pulley bolt so it came off without any issues. Crank ...
Updated 24-09-2012 at 09:59 AM by Kaz-kzukNA1 (Revised blog category.)
Warmed up the engine in order to carry out the compression check before start of the service. On installing the IG coils, I noticed that there was a small slit at the flex tube on one of the already repaired IG coil so will see what I can do or just replace it with the new/used one. [psi] #1: **0, ...
Although I managed to push back all pistons at the front calipers, the movement was not consistent. And as expected, there is no way I can re-use them…… None of the caliper slider pins were seized so it looked like someone serviced them in the past but not quite. All four pistons must be ...
Coolant header tank was already cracked at several places but magically, it was not leaking yet. It will be replaced any way during the full cooling system OH. ...
Updated 24-09-2012 at 09:58 AM by Kaz-kzukNA1 (Revised blog category.)
Very common on early model NSX. Oil pressure gauge was showing almost 0kg/cm2 at idle rpm after warmed up. Even during the test driving session, it was showing only around 2kg/cm2. I could replace the oil pressure sender unit to the later spec while the engine is out of the car but the accuracy of this ensor ...