The gasket for the existing thermostat was not installed properly causing small leakage around the area. Looks like I need to spend some time cleaning the area as there are lots of oxidation and debris from the leaked coolant. ...
Updated 14-10-2012 at 01:18 PM by Kaz-kzukNA1
While working on the coolant hoses, not much to say. Just keep draining the old coolant and removing the existing hoses. The existing coolant was red colour one so needs to be flushed really well. Draining the coolant from the front and rear engine block. As seen on several ...
On going testing of modified setup on Clock and CCU illumination. Under the daylight with the light switched on. This photo was taken when only the clock was modified. ...
So, started to work on another NSX. The service menu is to replace all of the coolant hoses, CL Hyd sys, ABS flush, etc, etc, etc… When the owner arrived at my place, he told me that his door mirror adjuster no longer works in the up/down direction. He had the mirror plate replaced ...
Replaced the fuel filter. Replacing it on NSX is easy if you have access to the air tool but MX5 is even easier. No need for the air tool. Although it was still operating fine, the pressure sensor at the power steering pump showed extra play compared to the new one so probably replace it ...
Recent Comments
Blog Categories
Archive
