When the car was delivered to me, the driver told me that he couldn’t open the fuel lid at the petrol station. The fuel lid on our NSX has very little clearance around it and while the lid is made from plastic, the rear wing is aluminium so two different materials reacting to the sudden temperature chance as soon as ...
The front bumper is too close to the bonnet and also the R side headlight cover is too low. Don't want to touch the bumper alignment as it will take hours so will try to adjust just the headlight cover later. ...
The owner has already collected his NSX from my place so doing some catch up updating the blog again.... Still changing all sorts of software for the new PC build but getting there.... Fuel Lid alignment On arrival, it didn't look nice. ...
Even with the fully charged battery, I felt as if the cranking speed of the starter motor was not up to the full speed. Once again, the battery terminal was overtorqued and very loose. I could remove it without even loosening the fixing nut. Since the damage was done to the cramp, best to replace the GND cable. For the ...
The owner reported that from time to time, he couldn’t open the lid. Adjusting the lid alignment is always tricky as the clearance is very narrow and while the lid, tip of the opener cable and nearby parts are plastic, the wing is aluminium so not sure how the temperature affects the gap considering the design of the lid area. Normally, I have to remove the wheel arch liner to rotate the opener cable tip but this ...
Blog Categories
Archive
Recent Comments
