In the past, I showed the example of chassis frame repairing work and recently, several NSX in Japan went through the similar services. You can find the past example here; http://www.nsxcb.co.uk/entry.php?40-NSX-Repair-01 (All of the photos in this post are from Mr Toyoizumi at KSP Engineering in Japan.) The following examples are carried out under the insurance work so the owners were very fortunate to be covered with ...
(All photos from Mr Toyoizumi at KSP Engineering, Japan) As same as the NSX factory, the polyurethane sealant was poured into the gap where the new frame was installed and then off to the paint booth. Almost done and start putting the parts back in place. ...
Updated 28-04-2012 at 11:45 AM by Kaz-kzukNA1
(All photos from Mr Toyoizumi at KSP Engineering, Japan) Pre-assembling the new frame. Using this jig, the chassis alignment can be achieved within 1mm offset. The new front ...
Updated 28-04-2012 at 11:44 AM by Kaz-kzukNA1
(All photos from Mr Toyoizumi at KSP Engineering, Japan.) Removing the damaged section. No damage at all to the side sill. ...
Updated 28-04-2012 at 11:42 AM by Kaz-kzukNA1