Eng Refresh, Health Check, etc 28
by
, 04-09-2019 at 12:58 PM (1387 Views)
Made mistake in routing the CRK/CYL sensor loom before placing the intake manifold.
Fortunately, new wire/corrugated tube so fairly easy to re-position without causing any damages.
This photo shows the correct position.
If old and hardened, you need to pay extra attention not to break the wire sleeve.
EACV, FIV and O2 sensors are not installed yet but pretty much the Eng Loom is now back in place.
Getting there…..
Kaz