Clutch Master/Slave Cyl

New spring loaded bolts and nuts at both CATs.

At the front CAT, I didn't like the idea of compressing the spring too far but in order to reach the specified torque, there was no option so may need to replace the swivel gasket. ...

Tags: cat bolt, koyo rad, o2 sensor, spring loaded bolt

Categories

TB/WP/Valve Service , Cooling , Clutch Master/Slave Cyl

Not much to report while placing the engine back in the bay.....




Removed the bracket, adjusted the shape as it was twisted in a strange way and re-installed the fuel filter.
Now the two pipes don't hit each other.



...

Tags: cl hose, cl hyd hose, cl hyd sys, eng installation, fuel filter

Categories

TB/WP/Valve Service , Clutch Master/Slave Cyl

Another place with high oil pressure that can cause oil seepage.
The oil press sender unit.
Replaced the o-ring and should be fine for many years.




As reported earlier, the IG coil harness holder ...

Tags: cl hyd sys, cl slave cyl, ig coil cable holder, ig coil harness holder, oil press sender, oil pressure sender unit

Categories

TB/WP/Valve Service , Cooling , Clutch Master/Slave Cyl

After hours/days of adjustment and testing, finally, happy with the result so started placing the parts back in place.

The dashboard sharp metal scratching against the key cyl area.
Should be fine once the dash gauge installed and secured but as a prec-aution, applied felt wool.





...

Tags: cl hose, cl hyd sys, cl master cyl, cl slave cyl, dashboard

Categories

Clutch Master/Slave Cyl , Body

Always apply high temp Urea grease at the Release fork saddle.
Otherwise, you will feel heavy friction with squeaking noise when CL pedal is operated.

Not required for DIY service but if you want to save the time and fluid, ...

Updated 10-06-2014 at 08:59 PM by Kaz-kzukNA1 (Layout)

Tags: cl master cyl, cl slave cyl

Categories

Health Check Service , Engine/Tyre , Clutch Master/Slave Cyl