Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Another place with high oil pressure that can cause oil seepage.
The oil press sender unit.
Replaced the o-ring and should be fine for many years.




As reported earlier, the IG coil harness holder ...

Tags: cl hyd sys, cl slave cyl, ig coil cable holder, ig coil harness holder, oil press sender, oil pressure sender unit

Categories

TB/WP/Valve Service , Cooling , Clutch Master/Slave Cyl

After hours/days of adjustment and testing, finally, happy with the result so started placing the parts back in place.

The dashboard sharp metal scratching against the key cyl area.
Should be fine once the dash gauge installed and secured but as a prec-aution, applied felt wool.





...

Tags: cl hose, cl hyd sys, cl master cyl, cl slave cyl, dashboard

Categories

Clutch Master/Slave Cyl , Body

Always apply high temp Urea grease at the Release fork saddle.
Otherwise, you will feel heavy friction with squeaking noise when CL pedal is operated.

Not required for DIY service but if you want to save the time and fluid, ...

Updated 10-06-2014 at 08:59 PM by Kaz-kzukNA1 (Layout)

Tags: cl master cyl, cl slave cyl

Categories

Health Check Service , Engine/Tyre , Clutch Master/Slave Cyl

The owner has already collected his NSX from my place so doing some catch up
updating the blog again....
Still changing all sorts of software for the new PC build but getting there....







Fuel Lid alignment
On arrival, it didn't look nice.



...

Tags: cl hose, cl master cyl, cl slave cyl, fuel lid, fuel lid opener cable

Categories

Health Check Service , Clutch Master/Slave Cyl , Body

Not much to report while putting the Eng back in place.





Gave good cleaning inside the eng bay.



...

Tags: cl slave cyl, coolant pipe, eng bay, eng installation, fuel filter, gbox gnd cable, pcv valve

Categories

Eng Refresh Stage 1 + LMA