Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

As seen on other NSX, the fixing screws were missing from the rear ceiling trim.
I will try to find the closest one from my spares.
Probably the same on your NSX....







...

Tags: aspirator fan, cabin temperature sensor, interior trim, roof locking mechanism

Categories

A/C CCU Board Service , Body

Finally, all the parts have arrived so I can now focus working on this NSX.




Just following up the brake service.

As we didn't replace the master cyl on this NSX, probably not required but as it's my standard procedure,
pressure bled the system in two rounds.
In between, left the system under pressure for about 1Hr to ...

Tags: ashtray, aspirator fan, audio head unit, pressure bleed

Categories

Brake , Body

The right side tail light alignment was not great against the bumper and
the centre & left tail light assy. ...

Tags: aspirator fan, cabin temperature sensor, eps rack, tail light, tail light assy, taillight assy

Categories

TB/WP/Valve Service , Health Check Service

The noisy cabin temperature sensor.
It was full of dust as reported earlier.
Disassembled, adjusted and now it’s clean.




...

Updated 30-11-2013 at 01:05 PM by Kaz-kzukNA1

Tags: aspirator fan, cabin temperature sensor, cooling fan control unit, fan control unit, fcu

Categories

A/C CCU Board Service , Heater, A/C , Electronics

Temporarily installed my re-soldered one for a test and confirmed the FCU failure.
The faint noise you can hear in the background after replacing the FCU is the
aspirator fan at the cabin temperature sensor.


As seen on many NSX, it was full of dust making this noise.


...

Updated 11-11-2013 at 02:33 PM by Kaz-kzukNA1

Tags: aspirator fan, cabin temperature sensor, eng gnd cable, fan control unit, fcu

Categories

Health Check Service