View RSS Feed

Eng Refresh Stage 1 + LMA

  1. Eng Refresh Stage 1 + LMA (SoS) – 09

    by , 08-05-2013 at 10:17 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)










    Same process for the rear bank.

    Cleaning process done, new LMA (from SoS) installed,
    rocker arms back in place and ready for the
    cam shaft installation.

    Torqued the sealing bolt for the rocker shaft
    with new washer.








    ...
  2. Eng Refresh Stage 1 + LMA (SoS) – 08

    by , 06-05-2013 at 10:43 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Back to working on this engine again.
    As I didn’t work on any mechanical parts for
    a few days, my finger sense won’t be up to the
    level for any processes requiring the delicate touch
    so decided to just clean the internal engine parts
    for the day.








    Full of old oil contaminated ...
  3. Eng Refresh Stage 1 + LMA (SoS) – 07

    by , 30-04-2013 at 10:37 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Couldn’t take lots of photos while my hands were covered in oil
    dealing with lots of rocker arms, etc so just the end result.







    All four cam shafts removed, holder plate and cam holders are
    now soaked in the cleaning solution.

    Will inspect the cam shaft in detail later.
    Considering
    ...
  4. Eng Refresh Stage 1 + LMA (SoS) – 06

    by , 29-04-2013 at 10:47 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)











    Very impressed with the state of the valve covers and
    the cleanness of the internal
    ...
  5. Eng Refresh Stage 1 + LMA (SoS) – 05

    by , 29-04-2013 at 10:46 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Forgot to attach this video file to the last post.




    The bearing at the A/C idle pulley was dead and making noise.
    Also, small part of the pulley edge was missing.
    Going to replace it with a new one.

    Placed parts order to Japan and just remembered that it’s time of
    the long holiday season in Japan.

    Lots of offices are closed until 06/May so hope it won’t
    ...

    Updated 30-04-2013 at 11:05 AM by Kaz-kzukNA1

    Categories
    Eng Refresh Stage 1 + LMA
Page 89 of 96 FirstFirst ... 39798788899091 ... LastLast