View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Low mileage LMA service 08

    by , 20-06-2013 at 10:37 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)







    This engine is equipped with the larger diameter VTEC spool valve
    so it’s the original design and thus, requires the ver.PR3 filters.

    Also, it is important to replace the bolts especially the short
    ones because they are exposed to the heat and moisture resulting
    in corrosion.
    Some owners broke these
    ...
  2. Eng Refresh Stage 1 + LMA (SoS) – 14

    by , 14-05-2013 at 10:36 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)










    VTEC Spool valve service.

    It can be done at any time without opening the engine
    but it’s a MUST item due to the process for
    replacing the LMA.

    This NSX is using the smaller
    ...
  3. Eng Refresh Stage 1 + LMA (SoS) – 07

    by , 30-04-2013 at 10:37 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    Couldn’t take lots of photos while my hands were covered in oil
    dealing with lots of rocker arms, etc so just the end result.







    All four cam shafts removed, holder plate and cam holders are
    now soaked in the cleaning solution.

    Will inspect the cam shaft in detail later.
    Considering
    ...
  4. Eng Refresh Stage 1 + LMA (SoS) – 04

    by , 27-04-2013 at 10:17 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)







    I don’t say it’s the same everywhere in UK but from
    what I saw in the past, full service history means
    almost nothing to me.

    Even with lots of stamps on the service log book,
    I always find lots and lots of issues on UK based NSX.

    The front valve cover and the seal were not installed properly.
    ...
  5. Eng Refresh Stage 2 – 13

    by , 01-01-2013 at 02:40 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    New filter gaskets and the bolts for later spec VTEC Spool valve.
    Must replace the bolts especially the vertical ones.









    Degrease the mating surface to this level.
    ...

    Updated 01-01-2013 at 02:42 PM by Kaz-kzukNA1 (layout change for mobile devices)

    Categories
    Engine Refresh Stage 2
Page 5 of 6 FirstFirst ... 3456 LastLast