Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Back to my favourite alignment platform.

I normally use customised setup based on UK road condition, driving style, etc.



SAI figures were almost identical so good news for the owner to confirm that
Front end seemed to be very healthy.


Bit of adjustment required on my custom setup for the ...

Tags: alignment

Categories

Alignment

The left side door and foot well speaker boxes are now back in place and
started working on the right side door.

As I don’t have enough time to finish everything in time before leaving for
the alignment service, decided to take the AMP out of the speaker box but
put almost everything back on the car before visiting the alignment platform.


...

Tags: amp, bose

Categories

Audio

Before visiting the alignment platform, it is my standard practice to check
the state of the alignment adjusters and apply silicone grease to the adjuster body.

Rear side was done while working on the drive shaft ...

Tags: alignment adjuster, eps

Categories

Alignment , EPS - Power Steering

Time to refurbish the AMP.
Don’t have much time this week so it’s going to be brief update.

Normally, I prefer taking all three AMPs out of the car in one go
but this time, I must be ready for the alignment session so decided
to work on the left side door and the foot well speakers first.
Then, re-install them, and if time allows, work on the right side
door AMP before visiting the alignment place.



...

Tags: amp, bose

Categories

Audio

The owner reported that from time to time,
he couldn’t open the lid.

Adjusting the lid alignment is always tricky as the clearance is very narrow
and while the lid, tip of the opener cable and nearby parts are plastic,
the wing is aluminium so not sure how the temperature affects the gap
considering the design of the lid area.

Normally, I have to remove the wheel arch liner to rotate the opener cable tip
but this ...

Tags: fuel lid

Categories

Body