View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Defrost panel, Bilstein damper, iPod adaptor 03

    by , 19-06-2014 at 11:09 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    Before removing the Alpine Audio Head Unit in preparation for the dashboard removal, temporarily installed the USA Spec PA11-HON.



    ...
  2. Final Touch 05

    by , 23-05-2014 at 01:22 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    About to return this NSX to the owner so this is the final catch up updating the blog, for now.....




    I have now covered 65miles of test driving session including several VTEC moments
    and just one check of over 7,000rpm slope test.
    No issues and no warning lights, cool down mode and back on the lift.
    Visually
    ...
  3. Eng Refresh, Health Check - Preparation 02

    by , 03-10-2013 at 10:16 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    Typical LMA noise on classic Honda engine. Inconsistent, comes and goes.
    Especially noticeable around 0:40 - 0:45 and 0:56 - 1:05.




    Small coolant seepage at the bottom side of the radiator.
    As mentioned many times, it is a consumable parts and
    must be replaced after some years.
    ...
  4. Health Check, Annual Service, Cabin Noise, etc 01

    by , 06-08-2013 at 10:38 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)








    For the installation of the BC coilover kit,
    had to remove the rubber seal under the bonnet.
    As expected, the clips were all dead.
    Replaced all of them.







    ...
  5. Interior noise 03

    by , 15-07-2013 at 10:47 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    The two parts at the upper side of this photo are for the
    windscreen upper molding and the bottom one is for
    the defrost panel that came in a strong cardboard box.









    Lots
    ...
Page 3 of 4 FirstFirst 1234 LastLast