View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. Koyo Rad, Cooling Sys, Washer motor 03

    by , 16-07-2014 at 10:19 AM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)

    New coolant hoses and cramps installed at the centre floor section and at the front compartment under the bonnet.




    ...
  2. Brake OH 01

    by , 12-07-2014 at 12:08 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)
    I thought it's going to be an easy life this week since I won't be working on another NSX until next week.
    Then, something came to my mind and suddenly I found myself placing the order for the front brake disc/pad and started disassembling the calipers....
    My boss was not impressed at all as it's her birthday very soon and we were supposed to be doing some shopping.....


    Moving on.....


    Ideally, I wanted to send the caliper and bracket to Bigg ...
  3. Brake OH 01

    by , 27-11-2013 at 10:26 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)



    As reported earlier, caliper pistons were in very poor condition.
    Only one of them could be re-used and other five had to be
    replaced with new ones.
    Parts for the front OH and addition to these, other chemicals are
    going to be used.


    ...

    Updated 28-11-2013 at 12:40 PM by Kaz-kzukNA1

    Categories
    Brake
  4. Brake OH 01

    by , 15-09-2012 at 10:57 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)


    Nothing new here….. Just keep cleaning the internal and external caliper parts…..




    Received the caliper and bracket back from Bigg Red.

    Once again, they had bubbling and running of polymer on a few parts but
    far better than the last occasion.

    In fact, you won’t notice them unless you really look for them.
    ...
  5. Brake OH 03

    by , 28-07-2012 at 10:37 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)



    After spending hours, finally I was happy to start re-building the rear caliper.






    Before and after shots of the pin bearing area at the cam lever.
    Also, the cyl wall is very clean now.

    ...
Page 3 of 4 FirstFirst 1234 LastLast