View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Kaz-kzukNA1's Avatar

    Eng Refresh, Health Check, etc 30

    by
    Kaz-kzukNA1
    , 11-02-2015 at 01:06 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)



    Torqued the crank pulley bolt to the spec and installed the ACG with the new belt.




    All coolant hoses around ...
    Categories
    TB/WP/Valve Service
    Comments 0 Comments
    Read MoreRead More
  2. Kaz-kzukNA1's Avatar

    Eng Refresh, Health Check, etc 23

    by
    Kaz-kzukNA1
    , 20-12-2014 at 12:57 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    Just keep buidling the engine in preparation for the installation.




    New two coolant hoses at the oil cooler.

    The rust around the hose was fairly thick but the other side was fine so for now,     ...
    Categories
    TB/WP/Valve Service
    Comments 0 Comments
    Read MoreRead More
  3. Kaz-kzukNA1's Avatar

    Eng Refresh Stage 1 – 03

    by
    Kaz-kzukNA1
    , 29-10-2012 at 10:08 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)










    As seen on all of the NSX, the oil seepage from the oil pan gasket.
    It is making the flywheel inspection cover area wet but not too bad.

    I hope it’s not from the crank end seal though.....     ...
    Categories
    TB/WP/Valve Service
    Comments 0 Comments
    Read MoreRead More
Page 3 of 3 FirstFirst 123