View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. Health Check, Brake OH, Koyo Rad, etc 03

    by , 28-09-2015 at 02:20 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)



    The front sway bar link at the left side was almost hitting the damper body.
    Not sure this was the cause of the 'clicking' or 'rattling' noise that the owner mentioned as I found so many other noises while test driving this NSX.
    ...
  2. Eng Refresh + LMA, Bilstein Damper, etc 34

    by , 25-04-2015 at 12:44 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)







    FR inner brake pad outer edge didn’t look making good contact against the disc.
    The calliper slider pins move freely and both pistons were pushed back using just finger so looked to be disc related.
    Replacing the
    ...

    Updated 25-04-2015 at 12:47 PM by Kaz-kzukNA1 ('droop', not 'drove')

    Categories
    Eng Refresh Stage 1 + LMA , Suspension , Brake
  3. Eng Refresh + LMA, Bilstein Damper, etc 28

    by , 17-04-2015 at 12:46 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)











    Ready to take the INJ to my local place where the race teams and many garages are using for the INJ cleaning.

    Part of the ASNU service network and pretty much using the similar cleaning equipment everywhere.
    Should be back today or tomorrow as they had to order replacement INJ filter
    ...
  4. Drive Shaft, Brake OH, etc 04

    by , 02-11-2014 at 04:27 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)






    As reported earlier, I found several issues on the brake system on this NSX.


    The rear caliper piston was not aligned properly against the pad pin that the piston was only pressing against about 5mm diameter pin and no pressure ...
  5. Annual Service, Health Check, Brake OH 07

    by , 12-08-2014 at 11:11 AM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)






    Once again, thank you to the continued support from Goodridge for providing their custom made brake lines based on our spec.


    Please note that the ones that
    ...
Page 3 of 5 FirstFirst 12345 LastLast