View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Goodridge Custom Made Brake Line

    by , 15-08-2011 at 11:30 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)



    After ordering many custom made Goodridge brake lines for our NSX and also other owners placed several orders using the same spec as mine, Goodridge has now kindly provided us with the special part no. for NSXCB members.

    [Edit: Please note that the following NSXCB special part no. is only recognised in the system at Goodridge UK and no other places such as their distributors or their worldwide offices.
    Also, at the time of writing, please note that Goodridge
    ...

    Updated 14-01-2015 at 10:32 PM by Kaz-kzukNA1

    Categories
    Brake , Parts
  2. Brake OH 04

    by , 24-05-2011 at 11:46 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)



    In the process of reinstalling the brake calliper and bracket with the new brake hose from Goodridge.



    Click image for larger version. 

Name:	SiliconeGrease.JPG 
Views:	1232 
Size:	203.1 KB 
ID:	9406

    As mentioned to other owners who took my brake service in the past, I always apply thin coat of silicone grease around each fittings and pipes to delay the future corrosion as much as possible.


    This will include the bleeder screw at the calliper as well.


    Because ...
    Categories
    Brake
  3. Brake OH 01

    by , 21-05-2011 at 11:17 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)


    Probably, the most neglected area on the UK based NSX, the brake system.


    After test driving so many NSX using exactly the same route and scenario, almost none of them passed my test for the brake system.


    The cause of the issue is simple.


    It was not properly overhauled (OH) at regular interval.


    In fact, on most of them, the system was never OH after they left the factory.
    ...
    Categories
    Brake
  4. TB/WP/Valve 03 – Brake Line issue

    by , 31-03-2011 at 11:27 AM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    While preparing the car to drain the coolant, I noticed that the brake line at the rear was very close to the sway (anti-roll) bar even at the full droop position.


    So, although it's going to slow me down, decided to put the tyres back on again and bounced the car a few times to settle the suspension and looked at the brake lines.

    Click image for larger version. 

Name:	RRbrakeHose.JPG 
Views:	1466 
Size:	182.8 KB 
ID:	8867



    This photo is from the Rear Right and the car is sitting on the ground
    ...

    Updated 23-04-2011 at 11:13 PM by Kaz-kzukNA1

    Categories
    TB/WP/Valve Service , Engine/Tyre , Fuel and Emissions , Brake
Page 3 of 3 FirstFirst 123