Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Ready to take the INJ to my local place where the race teams and many garages are using for the INJ cleaning.

Part of the ASNU service network and pretty much using the similar cleaning equipment everywhere.
Should be back today or tomorrow as they had to order replacement INJ filter ...

Tags: brake calliper, brake disc, brake pad, cl release fork, cl slave cyl, inj, injector, urea grease

Categories

Eng Refresh Stage 1 + LMA , Brake

The existing thermostat lost 2/3 of its rubber seal allowing the coolant to pass through during the warm up.
No wonder why it took ages to warm up in March.



...

Tags: coolant pipe, eng detailing, eng dressing, inj, injector, thermostat

Categories

Eng Refresh Stage 1 + LMA

So, started the engine to warm it up in preparation for
the compression check after the service and while measuring the
wheel stud bolt length for other purpose, the tappetty noise came back.


Back to the white board.


In fact, replacing the LMA cleared the background noise caused
by the sticky LMA and now I can distinguish two different noises.

Both noises seemed to be at the same frequency as the INJ pulse
so ...

Tags: inj, lma, vtec

Categories

Eng Refresh Stage 1 + LMA , Engine/Tyre

At #1 and #3 INJ base, noticed some sort of marking.
#2 was dry. It's the 2nd photo ...

Tags: a/c, a/c compressor, cat, compression check, compressor, eng refresh, exhaust, heat shield, inj, injector

Categories

TB/WP/Valve Service