View RSS Feed

Driveshaft

  1. Drive Shaft, Brake OH, etc 07

    by , 03-11-2014 at 10:36 AM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)


    What a busy weekend.......

    Only had short free time on Sunday so quick reassembly of the drive shaft.

    I didn't want to touch my mobile phone camera while dealing with that smelly custard cream CV grease so just the end result.

    Set the proper offset at 60deg between inboard and outboard spiders, filled the joint housing with the smelly grease, installed each rollers in original direction at their original position, adjusted the amount of air ...
    Categories
    Driveshaft
  2. Drive Shaft, Brake OH, etc 06

    by , 02-11-2014 at 04:40 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    My eyes..... Planting hundreds of pin bearing hurts.
    At my age, I started having trouble looking at objects too close so not good for my eyes....


    On top of this, the smell of this custard like CV grease..... I hate this and ...
  3. Drive Shaft, Brake OH, etc 05

    by , 02-11-2014 at 04:34 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    Right side drive shaft off the car and cleaned the area to this level. Lots of microfibre cloth used and my fingers sore....


    Despite loosing so much grease, surprisingly, the internal drive shaft parts were in good conditions. Better ...
  4. Drive Shaft, Brake OH, etc 01

    by , 02-11-2014 at 03:59 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    Following on from the seized drive shaft in the hub earlier, the owner took his NSX to another place and had the entire hub carrier removed and pressed the seized spindle out.

    Addition to this, the findings on the brake system made the owner to re-think about the priority of future services and instead of ...
    Categories
    Driveshaft , Audio
  5. Health Check, Cooling Sys, etc 16

    by , 16-10-2014 at 02:47 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)








    Over the last several days, I was tackling with the drive shafts on both R & L sides.



    As reported earlier, they were seized in the hub.



    First attempt using the hydraulic hub puller didn't work so I then drove the car for a while to put some heat and vibration ...
Page 14 of 24 FirstFirst ... 41213141516 ... LastLast