Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Warmed up the engine and time for the compression check.
Already reported to the owner but slight hesitation experienced on
the engine at this point although no CEL so probably just my ears
and feelings.

Full data has been informed to the owner through email.

[psi]
#1: **9 #2: **2 #3: **0 ...

Tags: battery, battery post, compression check, eng removal, gnd cable, th body, th butterfly

Categories

TB/WP/Valve Service

New gasket for the VVIS chamber and butterfly mechanism.




Must replace all ten washers.



...

Tags: egr pipe, gasket, intake manifold, tb adjuster bolt seal, tb lower cover, th body, vvis, vvis gasket

Categories

Eng Refresh Stage 1 + LMA

Some sort of debris baked into the surface of the IG coil cover.
Had to carefully polish it out.




New rubber seal installed and silicone grease will be applied later.



...

Tags: ig coil cover, insulator, tb lower cover, th body

Categories

Eng Refresh Stage 1 + LMA

A while ago when I replaced the coolant hoses on this NSX,
there were some heavy corrosion at the metal pipes.
However, the area behind the WP was very clean.

Normally I have to remove some slimy debris inside the trap chambe but
with this engine, there was just a tiny amount and it was one of the
most clean engine for this total mileage ...

Tags: intake manifold, th body, throttle body, valve guide, vvis, vvis plate, water pump

Categories

Eng Refresh Stage 1 + LMA

...

Updated 24-11-2013 at 02:05 PM by Kaz-kzukNA1

Tags: a/c belt, a/c belt tension, intake chamber, th body, vacuum fill, vacuum leak check

Categories

Cooling , Fuel and Emissions