View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Cooling Sys, etc 15

    by , 20-04-2021 at 09:14 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)













    ...

    Updated 17-05-2021 at 03:14 PM by Kaz-kzukNA1

    Categories
    Cooling
  2. Cooling Sys, Health Check, etc 10

    by , 14-06-2016 at 12:49 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)






    Getting back to normal speed from yesterday but had to be cautious as I didn't want ending up in similar situation by moving my back too fast especially while under the lift.



    ...
  3. Eng Refresh, Health Check, etc 09

    by , 17-01-2015 at 02:28 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)

    I need to check about this with the owner.

    Under the square side sill garnish near the fuel lid opener, there was a fuse block with one cable disconnected. Unfortunately, I already disconnected the battery so not sure whether it was getting any power or not but the other side of the disconnected cable was not connected to anything yet the fuse terminal was exposed with ...
  4. Cooling Sys 03

    by , 24-04-2012 at 10:39 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)


    After reconditioned the surface of the housing, new thermostat was installed.





    All the hoses in the engine bay replaced….
    What a short word for the time consuming several hours task….

    ...
  5. Cooling System 02

    by , 19-08-2011 at 11:38 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)





    Click image for larger version. 

Name:	HeaterCorePipe01.JPG 
Views:	1227 
Size:	105.6 KB 
ID:	10234

    The heater core bleeder pipe was kinked and looked to be slowly leaking from around the bleeder plug.


    It was super tight so I had to apply heat to loosen it and then found the reason for the kink as well as the leakage.




    Click image for larger version. 

Name:	HeaterCorePipe03.JPG 
Views:	1254 
Size:	178.1 KB 
ID:	10235
    Click image for larger version. 

Name:	HeaterCorePipe02.JPG 
Views:	1254 
Size:	115.8 KB 
ID:	10232

    There were so much corrosion inside the bleeder plug as well as inside the fitting ...