Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Doing bit of catch up as the engine has already been fired up......






Fresh Mobil 1 into the new oil filter.






Extracted about 400cc old oil from the oil level gauge ...

Updated 18-05-2013 at 10:32 AM by Kaz-kzukNA1

Tags: header, header tank, oil filter, thermo bandage, thermo wrap, zircotec

Categories

Eng Refresh Stage 1 + LMA

Intake Air Temperature (IAT) sensor.
Covered in oil with lots of black debris.








Cleaned it and although I couldn’t take the photo under good lighting,
it should look ...

Updated 16-05-2013 at 10:42 AM by Kaz-kzukNA1

Tags: a/c compressor, iat, iat sensor, ig coil, intake air temperature, o2 sensor, zircotec

Categories

Eng Refresh Stage 1 + LMA

This aftermarket header is about 5mm too short
for both the front and rear bank.

For OEM and other manifold/header,
I have to tilt the CAT during the engine installation because
the stud bolts will hit the mating flange.

With this header, I didn’t have to do anything because ...

Updated 24-04-2013 at 07:54 AM by Kaz-kzukNA1

Tags: eng oil, header, o2 sensor, oil filter, zircotec

Categories

TB/WP/Valve Service