View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. Cooling Sys, Health Check, etc 17

    by , 10-11-2020 at 02:42 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)







    Was already installed before carrying out the brake overhaul so the order of the photo and post won't match the actual timeline but these would help the owner when looking back the history.....






    ...
    Categories
    Suspension
  2. AC Refresh 09

    by , 20-08-2016 at 11:48 AM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)








    ...
    Tags: damper, flap Add / Edit Tags
    Categories
    Heater, A/C , My NSX
  3. Eng Refresh + LMA, Bilstein Damper, etc 34

    by , 25-04-2015 at 12:44 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)







    FR inner brake pad outer edge didn’t look making good contact against the disc.
    The calliper slider pins move freely and both pistons were pushed back using just finger so looked to be disc related.
    Replacing the
    ...

    Updated 25-04-2015 at 12:47 PM by Kaz-kzukNA1 ('droop', not 'drove')

    Categories
    Eng Refresh Stage 1 + LMA , Suspension , Brake
  4. Defrost panel, Bilstein damper, iPod adaptor 07

    by , 25-06-2014 at 12:28 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Started the installation of Bilstein damper but I accidentally deleted all of the photos except one that I took on Monday.
    Fortunately, it's just the repeat of same procedures so not perfect but took similar photos again.


    Originally, we were talking about installing the BC Coilover kit with Swift spring upgrade.

    However, after discussing the rideheight requirement with the owner, it became clear that it has to be very close to the OEM
    ...
    Categories
    Suspension
  5. BC Coilover with Swift spring 02

    by , 14-02-2013 at 10:17 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)










    Not much to report while installing the new coilover kit.

    Just remove the old tired original OEM coilover and
    install the new one.

    Front and Rear installed but not torqued to
    ...
Page 1 of 2 12 LastLast