View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Kaz-kzukNA1's Avatar

    Eng Refresh, Cooling Sys, etc 32

    by
    Kaz-kzukNA1
    , 27-09-2018 at 11:51 AM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)








     ...
    Categories
    Eng Refresh Stage 1 + LMA , Engine/Tyre
    Comments 0 Comments
    Read MoreRead More
  2. Kaz-kzukNA1's Avatar

    Eng Refresh 28

    by
    Kaz-kzukNA1
    , 16-05-2014 at 01:37 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    By now, I should have finished the 1st stage test driving session but
    I haven’t even managed to carry out the vacuum leak check on the
    cooling system yet so not fired up the engine at all.


    Things were going smoothly until I started installing the exh pipe.
    When I started working on this NSX, I noticed that some of the bolts and
    nuts were not torqued to the spec and bit loose but no cross-thread so
    I just thought     ...
    Categories
    Eng Refresh Stage 1 + LMA
    Comments 0 Comments
    Read MoreRead More
  3. Kaz-kzukNA1's Avatar

    Eng Refresh Stage 1 - 16

    by
    Kaz-kzukNA1
    , 30-05-2012 at 10:04 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)




    The replacement coolant hose under the centre floor.
    Comparison between the original one that was about to burst at the top and the new one below.


    It could have burst and loose all of the coolant on the way to my place or even during the test driving session after the service.


    Very scary……
     ...

    Updated 01-06-2012 at 09:56 AM by Kaz-kzukNA1 (typo)

    Categories
    TB/WP/Valve Service
    Comments 0 Comments
    Read MoreRead More